Results 1 to 10 of 10
-
02-01-2015, 04:17 PM #1
Will these bad edges on my strop cause problems?
When I received my strop in the mail it came in a mailing envelope, not box. I noticed the edges had gotten crushed in transit (I'm assuming). Are the edges bad enough to cause problems stropping? At the time I didn't want to be a whining customer. But as I get to know straights better I understand how delicate the edge is. Okay or should I contact the vendor?
-
02-01-2015, 04:35 PM #2
- Join Date
- Jan 2011
- Location
- Roseville,Kali
- Posts
- 10,432
Thanked: 2027If a quality strop.the edges should have been beveled,others will chime in,do not think it is an issue if you use an X stroke..
CAUTION
Dangerous within 1 Mile
-
The Following User Says Thank You to pixelfixed For This Useful Post:
57vert (02-01-2015)
-
02-01-2015, 05:54 PM #3
- Join Date
- Jan 2008
- Location
- Rochester, MN
- Posts
- 11,552
- Blog Entries
- 1
Thanked: 3795Personally, I would not want to risk it. If the seller cannot pack it right it's not your fault. I'm also a bit concerned about the pebbling of the leather shown most prominently in the lower right of the photo.
-
The Following User Says Thank You to Utopian For This Useful Post:
57vert (02-01-2015)
-
02-01-2015, 06:37 PM #4
- Join Date
- Feb 2013
- Location
- Haida Gwaii, British Columbia, Canada
- Posts
- 14,443
Thanked: 4828I would give it a quick rub with some smooth glass and see if it went flat. If it doesn't bounce back quite fast then contact the vendor.
It's not what you know, it's who you take fishing!
-
The Following User Says Thank You to RezDog For This Useful Post:
57vert (02-01-2015)
-
02-01-2015, 07:32 PM #5
Are the edges curled up or down? On an old strop it may or may not matter, if the strop is new, shame on whoever packed lit in an envelope. I have sold a few strops, both vintage and handcrafted and I always sent them in a 6x6x6 box, coiled with the leather on the outside of the coil to keep the leather from scrunching up.
It is easier to fool people than to convince them they have been fooled. Twain
-
The Following 2 Users Say Thank You to nun2sharp For This Useful Post:
57vert (02-01-2015), cudarunner (02-01-2015)
-
02-01-2015, 08:37 PM #6
If the edges are slightly turned up, what about tapping them down and flattening them out with gentle hammering?
-
The Following User Says Thank You to wayne394 For This Useful Post:
57vert (02-01-2015)
-
02-01-2015, 08:47 PM #7
I would give it a couple days of some good old palm rubbing and see if it helps them go away. If not I would contact the seller.
I am still surprised at what palm rubbing does to leather.
-
The Following User Says Thank You to Redcane For This Useful Post:
57vert (02-01-2015)
-
02-01-2015, 08:48 PM #8
Or better yet, palm rub and then do what RezDog said.
-
02-01-2015, 08:52 PM #9
I have tried the palm rubbing previously. Just tried the glass bottle and it did nothing. It is a reputable vendor, I'll contact him. I should have done it right away, but again, I didn't want to be a "problem" customer. I also thought that over time the wrinkles would naturally go down while hanging.
-
02-01-2015, 10:45 PM #10
You didn't say what type of strop it is or the quality. A quality strop should be free from all defects. If it was mine it would have gone back in an instant.
No matter how many men you kill you can't kill your successor-Emperor Nero
-
The Following User Says Thank You to thebigspendur For This Useful Post:
57vert (02-02-2015)