Results 1 to 10 of 11
Like Tree19Likes

Thread: Changing Leather Characteristics?

Hybrid View

  1. #1
    Skeptical Member Gasman's Avatar
    Join Date
    Nov 2016
    Location
    Colorado Springs
    Posts
    10,486
    Thanked: 2186

    Default

    I'm looking to go the other direction. Faster with less draw.
    Brontosaurus and RezDog like this.
    It's just Sharpening, right?
    Jerry...

  2. #2
    Senior Member blabbermouth
    Join Date
    Apr 2012
    Location
    Diamond Bar, CA
    Posts
    6,553
    Thanked: 3215

    Default

    Is it a new strop?

    You can add oil to leather sparingly and roll the strop to make it supple. I have done it to several new and rehydrated stiff vintage strops.

    Add oil sparingly and slowly. First dampen the strop on both sides with a wet sponge, do not soak just wipe with a damp sponge. Wait 15-20 minutes to allow the water to penetrate deep into the leather. The water will open the pores of the leather and allow the oil to penetrate deeply and evenly.

    Take a ½ teaspoon of neetsfoot oil or Ballistol to a small dish, fold a paper towel into a small pad about 2x2 inches. Dip the pad in the oil, apply to the face side of the strop in the middle and wipe from the middle out.

    Coat the face side of strop with a light coat of oil. Hold the pad over any spot that needs more oil, it will wick from the pad. Work it into the leather with the pad. Do not add any more oil at this time or you will clog the pores of the leather and if too much is added too quickly it can cause rotting. Now wait a day, you will see the color even out and the strop will be a bit more flexible.

    Pick up a rolling pin from a thrift store and hang it from the ceiling, I use my garage door with a couple pieces of Para cord. I first began using this technique to clean and make Firehose strops more flexible and posted photos in this thread. (Oak fanned English shell, Adrian, Michigan).

    If the strop is flexible, gently put the strop on the roller and lightly roll it, if it feels stiff do not over bend it. Do not bend more than 45 degrees the first time. Bend in the other direction rolling lightly. Wait a couple days and roll it again, flexing a bit more each time. Do it slowly over a period of days allowing the oil to penetrate further, it can take a couple weeks to a month for the oil to fully penetrate.

    If stiff do not push it, bend lightly. Wait another week and apply another coat of oil after wetting the leather and waiting for it to absorb. After a couple days, roll again lightly do not over do it and stop if you feel the leather cracking.

    The trick to adding oil is use a small amount and allow it to absorb into the leather. It may take a couple months to make the leather soft and flexible. If it is a vintage strop, it can take months to re-hydrate a dried strop. Go slow and do not add more that a teaspoon at a time, once every 2 weeks to a month. Less oil is better, keep flexing the strop on the roller, bending a little more each time.

    Eventually the strop will become more flexible and the draw will increase with the hydration of added oil. In time the strop will be as flexible as an old well washed sock. Go Slow it can take months, to hydrate and soften a vintage strop.

    Just because a strop is new does not mean it hasn’t sat in a hot warehouse for months.

    If you want to give the leather a more nap finish, like suede, I find it is better to lightly scrape the leather laid flat on a table with a sharp cabinet card scraper, than to sand. Sanding will leave micro bits of grit that will imbed into the leather and scratch rather than polish a bevel. You can make an inexpensive strop into a nice flexible strop with a little work and a lot of time.

  3. The Following 6 Users Say Thank You to Euclid440 For This Useful Post:

    DZEC (12-06-2018), FatboySlim (12-15-2018), Gasman (12-05-2018), jfk742 (12-06-2018), outback (12-05-2018), Steel (12-05-2018)

  4. #3
    Senior Member blabbermouth outback's Avatar
    Join Date
    Mar 2015
    Location
    Akron, Ohio
    Posts
    11,975
    Thanked: 4304

    Default

    Quote Originally Posted by Gasman View Post
    I'm looking to go the other direction. Faster with less draw.
    I've wiped a strop with a clean rag and some rubbing alcohol, for that reason. It had a bit too much oil in it, after restoring, Jerry.

    Josh, try hand rubbing till the leather warms up. It works for me. But I like a slick Bridle, for the most part. Guess that why I have different strops, their all different draws.
    Euclid440, Steel and Gasman like this.
    Mike

  5. #4
    Senior Member blabbermouth bluesman7's Avatar
    Join Date
    Jul 2014
    Location
    Denver CO
    Posts
    4,577
    Thanked: 810

    Default

    I increased the suppleness of my boarhide strop by rubbing a small amount of mink oil into the heel of my hand and then rubbing my hand onto the water dampened back sideof the strop.
    sharptonn, Gasman and DZEC like this.

  6. #5
    Senior Member
    Join Date
    Aug 2014
    Location
    East Central Illinois
    Posts
    782
    Thanked: 101

    Default

    Try Ballistol ! It just works. check it out a ballistol.com

    Slawman

  7. #6
    Senior Member blabbermouth bluesman7's Avatar
    Join Date
    Jul 2014
    Location
    Denver CO
    Posts
    4,577
    Thanked: 810

    Default

    Quote Originally Posted by Gasman View Post
    I'm looking to go the other direction. Faster with less draw.
    I've had luck with Kiwi saddle soap.
    Gasman likes this.

  8. The Following User Says Thank You to bluesman7 For This Useful Post:

    Gasman (12-05-2018)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •