Results 1 to 3 of 3
  1. #1
    Junior Member
    Join Date
    Aug 2011
    Posts
    12
    Thanked: 0

    Default Is this strop salvageable?

    I am new to this forum and was hoping to get a little assistance. I acquired my grandfather's razors, hones and strop. I don't know exactly how old everything is but I am guessing at least 50+ years based on my mother's memory. The razors I have sent out to be refurbished (and I will post pics in the proper forum when they come back) and I have posted pictures of the hones in the proper forum. I was hoping some folks could help me determine if this strop is usable. Im guessing it's 50+ years old. I know it may be hard to determine from photos - i will gladly answer questions or take more photos if folks think it will be helpful. Thanks so much for any guidance.Name:  IMG_1262.jpg
Views: 176
Size:  40.4 KBName:  IMG_1264.jpg
Views: 170
Size:  40.7 KBName:  IMG_1263.jpg
Views: 175
Size:  63.6 KBName:  IMG_1265.jpg
Views: 174
Size:  42.6 KB

  2. #2
    Senior Member blabbermouth JimmyHAD's Avatar
    Join Date
    Feb 2008
    Posts
    32,564
    Thanked: 11042

    Default

    Hard to say from the photos but I would say maybe. If there are no deep nicks in the horse or bad bends that have left creases it ought to be. I'd treat it with saddle soap, not getting it too wet, and then lightly apply neatsfoot oil. The lumpy linens I've gotten with vintage strops responded well to a wash in cold water in a bucket with Woolite. Then air dry flat with a telephone book or something like it laying on it. If you run your fingers over the surface of the leather you want it to be smooth. Some guys sand them if need be but if you can leave the finished surface of the original intact you're better off IMO.
    Be careful how you treat people on your way up, you may meet them again on your way back down.

  3. #3
    The Hurdy Gurdy Man thebigspendur's Avatar
    Join Date
    May 2005
    Location
    New Mexico
    Posts
    33,045
    Thanked: 5020
    Blog Entries
    4

    Default

    It's hard to tell from the pics because you can't tell the surface condition. If it's smooth and supple and not overly dry and as Jimmy said free from nicks and cuts and creases you should be OK. I' not a big fan of sanding unless it's to get a small cut out. I would rather clean and condition.
    No matter how many men you kill you can't kill your successor-Emperor Nero

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •