Results 1 to 8 of 8
Threaded View
-
10-01-2013, 09:30 PM #1
- Join Date
- Jun 2007
- Location
- North Idaho Redoubt
- Posts
- 26,985
- Blog Entries
- 1
Thanked: 13234Step away from the Duck and No one gets hurt :)
Shane sent this one out to me, we both were shaking our heads trying to figure out what was done to this poor DD...
This is what flew out North to Idaho..
I did some really careful file work then some even more careful drill work with a pin vise then more filing and more drill work and finally got it all loose and off there.. It was actually two hand made soft steel washers, and possibly a nail that had been beat on there carefully enough that there were no cracks in the scales
I cleaned up the scales and the steel and put it back together with some tiny SS washers on the outside and NiAg pins, used Brass bearing washers on the inside and it all works right again
I have left to do is clean up the heel and get rid of the hook back there, and finish honing her upLast edited by gssixgun; 10-01-2013 at 09:34 PM.