Results 1 to 10 of 19
Thread: Annealing rod for pins
Threaded View
-
11-06-2013, 09:37 PM #1
Annealing rod for pins
I was following a thread recently that discussed peening without washers and I think it was Pixelfixed who suggested annealing the rod beforehand. As I know nothing about this I assume that he meant that this would soften the rod and make it less likely to crack the scales.
So my question is - how do you go about this, in a domestic environment? i.e. I don't have a forge or any other source of fierce heat.