Thread: Best procedure to 're-round' the pivot hole using brass sleeve insert?

Alright so I considered all of your advice and decided to drill anyways. I think if the situation was different, I would not have drilled the tang. Here is why: The amount of metal I ended up needing to remove was so insignificant, but now i can fit the next size of tubing with virtually no play (which this razor obviously had a considerable amount of, and the edge of the blade kept hitting the scales): Here are some pictures to show:



Also I would like to say that in my original post I said that i was going to drill to 1/4 inch, and if you have not inferred already I meant 1/8 inch