Results 1 to 10 of 14
Thread: Now I'm just laughing.
Hybrid View
-
03-04-2014, 06:29 PM #1
- Join Date
- Jan 2011
- Location
- Roseville,Kali
- Posts
- 10,432
Thanked: 2027
-
03-04-2014, 06:39 PM #2
-
03-04-2014, 06:58 PM #3
I have had that happen to me before with an unstabilized burl and of course it has to happen right when they are finished. That would have been a beautiful set of scales.
Last edited by JSmith1983; 03-04-2014 at 07:00 PM.
-
03-04-2014, 07:05 PM #4
Yes, they will always be cracked but as Geezer points out a careful fix with CA could render it almost invisible. Back them by epoxying on some carbon plate and they are repaired structrally as well. I will give the OP enough carbon fiber plate (.025") to back both sides of the scales. Send me the gross dimensions of the scales and your mailing addy by PM if you want to do that.
The easy road is rarely rewarding.
-
03-04-2014, 08:45 PM #5
Thank you for the kind and generous offer but I'm done with those scales. They where already backed with .01 brass. I was fitting a temporary screw in the pivot with the center screw in place to see how wide a brass spacer I needed to get the blade spine to fall parallel with the scales when I gripped too tightly and flexed it enough against the center to crack it. I have a lot of trouble with the little screws, nuts, and washers so the frustration was mounting.
Than ≠ Then
Shave like a BOSS
-
03-04-2014, 09:00 PM #6
I feel your pain. My cross cut black palm (stabilized even) scales were broken 3 times before they were done. I got the carbon ordered after the first break and continued to work on them. Cracked them again before it arrived. Finally, they were done, one of my airport friends (lots of composite structures experience) was over and looking at them. He decided to see how flexible they were (while my back was turned) and broke one. Answer...the palm isn't as flexible as the carbon!
I simply re-did the CA finish. Even knowing that they had been broken, you would be hard pressed to find it on the razor now.The easy road is rarely rewarding.
-
03-04-2014, 11:36 PM #7