Thread: Chipping of blade from buffer.

4 inch wheels
Light pressure
and above all else

DO NOT Run the wheel into the edge, if you are buffing spine to edge, you have to make SURE that the edge is pointing straight down and that the buffing wheel is not impacting into it, rather than just gliding over it.. Someplace on here I have pics of this and it makes way more sense seeing it rather than explaining it...


Keep in mind that a 8 inch buffer running at 3450 is the same SFPM as a 4 inch Buffer running at 1725 the 4 inch wheel also lets you get into the hollow better


here

http://straightrazorpalace.com/works...tml#post623194