Thread: Cleaning pivot

Gents,
any suggestions for removing active rust at the pivot without removing scales.. The blade is in mint condition besides the very lil bit of rust at the pivot..??

floss? small tab of metal polish on a q-tip?

Pipe cleaners work well, especially the ones with plastic bristles.

Sometimes I hesitate to give this advice...

Warning these things are dangerous to your skin and eyes wear safety glasses and Nitrile gloves when you use them, I know they seem safe but get the fibers in your fingers and then in your eyes and you will be VERY sorry...


Amazon.com: Fiberglass Rust Brush Detail Prep & Cleaning Tool: Automotive


These work very well, just be careful using them

A good beginning is to take a q-tip, smash it with a hammer, and dip it into some damp Comet or Ajax. Amazing how much it will do for the pivot and the insides of the scales. Gets a lot of rust out. Scrub and move blade around, scrub some more. Q-tips are cheap. If it gets floppy, get out another one! Rinse well, blow out pivot with compressed air. Then do same with Maas or semichrome polish.
Don't cut yourself!

Not quite as dangerous as fibreglass but If you have a dremel these little abrasive wheels spinning @ 19k rpm do a great job on tangs .

Those little detail tools Glenn writes about are really good at that as well as a number of other cleanup uses. Definitely heed the warning about protection though. That said, I've used them on pivot areas, etchings, scale embossing and inlay, and countless other things. Inexpensive and effective. Where I once used a Dremmel I now use those prep tools with much less possibility of too much material being removed.

+1... One of the best tools to use and as Euclid says quite inexpensive and they last a pretty long time as well.

Originally Posted by onimaru55

Not quite as dangerous as fibreglass but If you have a dremel these little abrasive wheels spinning @ 19k rpm do a great job on tangs .

I took this advice a long time ago and it had paid off very well. And yes it does shed fiberglass in the finest form. If you get one buy 3 :<0)

And yes your right pixel. IMHO it should come apart if there is active rust. Not that hard to do it right.

Originally Posted by gssixgun

Sometimes I hesitate to give this advice...

Warning these things are dangerous to your skin and eyes wear safety glasses and Nitrile gloves when you use them, I know they seem safe but get the fibers in your fingers and then in your eyes and you will be VERY sorry...


Amazon.com: Fiberglass Rust Brush Detail Prep & Cleaning Tool: Automotive


These work very well, just be careful using them

Originally Posted by gssixgun

Sometimes I hesitate to give this advice...

Warning these things are dangerous to your skin and eyes wear safety glasses and Nitrile gloves when you use them, I know they seem safe but get the fibers in your fingers and then in your eyes and you will be VERY sorry...


Amazon.com: Fiberglass Rust Brush Detail Prep & Cleaning Tool: Automotive


These work very well, just be careful using them

I just bought 8 replacement "tips" for mine. It is probably the best tool I have in my case.