Thread: dremel marks

I have just bought a boker no 386.
its not in too bad a condition, no rust, scales clean and whole and the markings sharp and deep.

My problem is it looks like it has been previously 'restored' just very badly. I think it has dremel marks or some other power tool does anyone have any ideas on how to get rid of them? currently i am just working at it with 280grit sandpaper.

sorry the picture isn't great but you get the idea of what i mean

cheers

Some/many blades display "grind" marks. Given that the "markings are sharp and deep", I'd consider that, before going any further.

I wrap strips of wet dry sand paper around old wine corks and wet sand with WD-40. After I have gotten to 2kgrit I use steel wool and mothers, and then just mothers. Start with a higher grit 1k or 1.5k and drop down or climb up as need be.

Originally Posted by RezDog

I wrap strips of wet dry sand paper around old wine corks and wet sand with WD-40. After I have gotten to 2kgrit I use steel wool and mothers, and then just mothers. Start with a higher grit 1k or 1.5k and drop down or climb up as need be.

#0000 steel wool?

Joe

Originally Posted by carrolljc

#0000 steel wool?

Joe

Yes. The synthetics works as well. I seem to recall having used 000 with mothers once then the 0000 but it was because my blade was still really scratchy looking. It is not very aggressive so you can play around with then a little bit and if it isn't where you need to be it doesn't take long to remove it. Compared to many here I'm still fairly novice and still messing about trying to get my methods perfected.

Try sanding in the opposite direction as the marks. Horizontal verves vertical. About 50 strokes, then check for progress, It should lessen the appearence. Then switch to circular sanding motion 50 circles. Alternate as needed. You see I did the same thing, thats how I fixed my Opps . Ok truth is after I did it a second time, I took a dremmel with the steel wool attachment to it on low speed and that fixed it in about 30 seconds.Your choice keep us posted on how things go.

Originally Posted by ultrasoundguy2003

Try sanding in the opposite direction as the marks. Horizontal verves vertical. About 50 strokes, then check for progress, It should lessen the appearence. Then switch to circular sanding motion 50 circles. Alternate as needed. You see I did the same thing, thats how I fixed my Opps . Ok truth is after I did it a second time, I took a dremmel with the steel wool attachment to it on low speed and that fixed it in about 30 seconds.Your choice keep us posted on how things go.

I've come to the realization on a couple of occasions that I don't have to be a slave to one method or the other while going through a repetative up and down cycle of hand sanding or a back and forth with the buffer grits to remove scratches missed on previous passes. Sometimes an intervention with the other method with the appropriate grit seems to get things back on track. (just what the comparative grit between the two is still not clear to me but I err on the side of caution) I still think there are places that buffing just won't work well.

pic is not good enough to see, but all razors have grind marks.
If you can take a pic that shows the blade better I will be able to tell you if the grind marks are Dremel or belt.

ok i think i have done an alright job on at least minimising it. just used wd40 and sandpaper from 280-2000. it can only be seen on the right angle and right light. its a pretty schmick razor, its a shame i am giving it to a buddy for his 21st.

cheers for all the help

and thanks rezdog for the wine corks tip! it makes it a lot easier!