Results 1 to 10 of 11
Thread: Hinge pin hole
Threaded View
-
10-27-2014, 05:02 PM #9
- Join Date
- Jun 2007
- Location
- North Idaho Redoubt
- Posts
- 26,986
- Blog Entries
- 1
Thanked: 13234I have to agree
We basically have created the issue of the Point hitting the Wedge as restorers by closing the tolerance gap between the two in our builds.. This isn't a bad thing, but keep it in mind when trying to get tighter tolerances one sometimes creates different issues
I have never drilled a pivot hole out, I have a few different sizes of brass tubing on the bench they all fit inside each other, if the smallest tube 1/16 ID 1/8 OD doesn't fit inside the hole, then it really doesn't need a sleeve JMHO and a few restored razors..
Leaving just a tiny bit of slop in the pivot many times has been a very helpful thing in a build,,,