Need info from a woodworking expert

[prodigy]

Ok, i bought some blanks of wood to form into scales. One set is 1/2 thick, so in my mind i can cut this in half and make 2 sets of scales. What would be the best way to make this happen? I dont have any tools myself, but im a college student, and im sure someone in one of the machine shops can hook me up if i ask. Thanks! The dimensions are 6 in long, 2 in wide, 1/2 in thick.

[HARRYWALLY]

1/2" devided by 4 is 1/8". Unfortunately, you have saw kerf to worry about. Each time that blade passes through the stock of wood, your loosing a 1/6" off the size. Just to be clear, each pass through the wood turns 1/16 into dust. You may only get three pieces that are thick enough to use as scales.

[prodigy]

Yea I ordered 3 total, the other 2 are 1/4 thick. I'm just going to sand them to use able thickness. I would be happy to get 3 from 1/2 in, but was shooting for 2. So now that I know it is possible, what is the preferred tool and method to do it. I'm sure I would need a jig of some sort right? It would be hard to free hand that through a bandsaw, at least for my unskilled hands.

P.S. I won that first ebay listing I showed you of the buckeye burl!

[Utopian]

So now that I know it is possible, what is the preferred tool and method to do it. I'm sure I would need a jig of some sort right? It would be hard to free hand that through a bandsaw, at least for my unskilled hands.

I think you are asking about resawing. This can be done on a bandsaw with a fence or a jig. This is an easy job for google.

[UKRob]

If you don't have access to a bandsaw, a Japanese rip saw is the next best option. I'm no carprnter but have used one of these on wood and horn - it's much easier than hand sanding.

[JSmith1983]

A bandsaw would probably be the easiest way. I have used a scroll saw to cut 3/8 thick stuff before, but it was a PITA. Once I got a bandsaw I haven't used the scroll saw since. If you are careful cutting you probably could get 3 slabs from it, but I never like doing that unless the wood is tight grained and you wouldn't be able to tell if they were book matched. I like to keep each scales to look somewhat similar in grain pattern.

[MikeB52]

If you don't have access to a bandsaw, a Japanese rip saw is the next best option. I'm no carprnter but have used one of these on wood and horn - it's much easier than hand sanding.

+1 on the Japanese pull saw approach. If you do not have access to proper shop.
I have one and have used it to cut scales out of hardwood floor remnants. Wear gloves and let the tool do the work and it works marvy.
Can get one for under $30 at most better hardware or tool supplies. McMaster Carr as well.
Cheers.