Thread: Little nick

Ok so I ground it down with the dremel making sure not to let it get hot.
how do I reset the bevel, I only have a norton 4k/8k it seems like it will take some time with that so maybe Sandpaper but what grit/grits

btw it came out at 19/32

from measurements and good old math, the bevel only has a 3 degree change 7 to 10 does that sound right

looks cool.. what did it finish up as 4/8 or was there more meat on the bone after you ground out the nick?

Originally Posted by tgparker

looks cool.. what did it finish up as 4/8 or was there more meat on the bone after you ground out the nick?

it came out at 19/32 not sure what you mean by meat on the bone.

cool!

not quite 5/8 but a tad more than 4/8, I'll bet it will still shave fine!

All the best!

Tony

I my have a go at doing that to a 6/8 razor i have with a similar sized chip out of the blade

Not too shabby! Get some 1000 grit wet/dry paper, lay it on a very flat surface and draw circles with the blade until it's sharp. Tape the spine. I'd really recoment you buy a 220k 1000k Norton combo for the job.

X

better pic

Nice! And to think you were considering "binning" it!

- Scott