I had my eyes set on several wheels of 2, 2.5, sand 3" diameters. We have a set of very large punches that I was eyeing up for making the pieces. I fell down on trying get get my center hole lined up with the outside. I am sure it is possible, just above my pay grade. Perhaps if I looked into a better technique it would work. I just thought I would move on to the next build concept before spending a ton of time and material perfecting the solid wheel. I have a couple of the commercial strop wheels, they certainly work well at getting chisels and plane irons super sharp, but had not connected the dots to using them for razor restores.