Thread: T. Hessenbruch

That things needs some TLC. Ill have to remember about the SE. I bet that will come in handy..

And i wish i had a wire wheel right now. This took me most of the afternoon.. just one side, up to 2000 grit from 150.



Thanks again for the help.

Originally Posted by MW76

That things needs some TLC. Ill have to remember about the SE. I bet that will come in handy..

And i wish i had a wire wheel right now. This took me most of the afternoon.. just one side, up to 2000 grit from 150.



Thanks again for the help.

Looking good. But you should sand across the blade (spine to edge) your removing the sharp lines on the stabilizer and thinning the spine.
Heres pics after cutting the rust off.
More than happy to help walk ya thru it. Many have done this for me, and may even step in while were at it. To possibly help me as well, as I restore this blade.