Thread: Wedgy spacer..

Firstly i apologize for the picture quality on these. Im out the door to hit the antique shops but i was hoping to generate some answers to this before tomorrow. Takin' pics on the run with my celly..

I made the mistake of creating a very wide 'wedge' for a set of scales i recently made. I can tell from pinching them at the pivot end they are going to bow out a bit more then i like after they are pinned.

I used CA glue to glue the wedge in place and it has a few coats of button lac over it. I would like to somehow thin this wedge down to make a better fit so the razor doesn't sit as low in the scales when closed.

Right now i am imagining i can used debonder and a razor blade to get one side unattached, then sand it down and reglue. Seems simple enough but usually when i think that something goes wrong.

Let me know what you think guys. Should i mess with it? Is there a better way?

I can honestly say ive never been misinformed here so im looking forward to any replies.

Have a good day sirs.