Results 1 to 10 of 11
Thread: Original Washers?
Threaded View
-
08-18-2017, 01:03 PM #6
Too big of words for me. Ha. But if it was solid, The flat side against the scale. Then the raised, smaller part goes up away from the scale. These are not solid so they are hollow but then a very tiny washer is put inside of the fancy one as a space filler. the way they are sitting in the picture is the way they would sit on the scale.
Hope that helps.It's just Sharpening, right?
Jerry...
-
The Following User Says Thank You to Gasman For This Useful Post:
Brontosaurus (08-18-2017)