Results 1 to 3 of 3
  1. 07-13-2007, 03:19 PM #1
    Michael-
    Michael- is offline
    Member Michael-'s Avatar
    Join Date
    Jul 2007
    Location
    just North of New York City
    Posts
    26
    Thanked: 0

    Default Nick at the Point

    My straight has a small nick, just beyond the blade. It is a 5/8 half hollow TI with a round point. Since the nick is beyond the cutting edge, would the easiest and best solution be to hone dull and flat that spot at the bottom of the round point? If anyone has any suggestions please advise.

    Thanks
    Reply With Quote Reply With Quote
  2. 07-13-2007, 05:35 PM #2
    ucliker
    ucliker is offline
    Senior Member ucliker's Avatar
    Join Date
    Apr 2007
    Location
    Boulder, CO
    Posts
    333
    Thanked: 1

    Default

    Hello and welcome to SRP! well if you had a picture it would greatly help the situation!
    Reply With Quote Reply With Quote
  3. 07-13-2007, 06:55 PM #3
    Michael-
    Michael- is offline
    Member Michael-'s Avatar
    Join Date
    Jul 2007
    Location
    just North of New York City
    Posts
    26
    Thanked: 0

    Default More on the Nick

    Thanks for your reply. I don't think that a photo would help. The nick is too small to show in a picture. However It can seen with photographers loop and it can be felt. I hope that gives a better idea of how small it is. My last post gave a pretty good indicates of the nicks location. All repair suggestions would be welcome.

    Thanks
    Michael-
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules