Results 1 to 10 of 13
Threaded View
-
10-03-2018, 09:25 PM #7
I had the same problem when I used the dremel press, it got better when I bought a nice drill press..
But still had a little challenge with heating up the pin and melting plastic scales. Then tried applying more pressure only to have the drill bit flex and slip onto the scale.
So I got a short bit and that fixed that problem.
I like the dremel grinder wheel technique, but I also messed up some scales doing that!
EDIT: Oh and also, I put a dremel grinder wheel on my drill press and held the razor up to the wheel, this allowed me two hands to steady...Last edited by MikeT; 10-03-2018 at 09:27 PM.
“You must unlearn what you have learned.”
– Yoda
-
The Following User Says Thank You to MikeT For This Useful Post:
DoughBoy68 (10-03-2018)