DD Satinedge Scales

[yondermountain91]

So I have a satinedge on its way in the mail, and she has broken scales. I was on masecraft last night looking at materials, and i'm not sure what color I should go with. I would like to try and match the original color as close as I could. I am also planning on using the old bolsters on the new scales. I'm sure someone has already done this and could offer some input. I have only made two other sets of scales so am no expert by any means. However I am a carpenter by trade so like to think I'm pretty good with my hands. Thanks in advance for any help my dudes.

-Laramie-

[gssixgun]

DD Satinedge scales were clear when they left the Factory, Yes Really

DD Goldedge and Wonderedge left the factory with White Cracked Ice scales

The Yellowing we see now is due to the Catlin Celluloid breaking down

There are several threads on moving Bolsters and Inlays over going all the way back to the one Floppyshoes and I did about 12 years ago

[outback]

Odd..I have a set that are a translucent, pale green, color.

Blade was trashed, but scales look new.

[BobH]

Odd..I have a set that are a translucent, pale green, color.

Blade was trashed, but scales look new.

Odd, on my monitor I'd have to say they were translucent yellow. Can't see the green in them.

Bob

[JP5]

I thought most clear celluloid ended up a darker yellowish color over the years like the Case Temperite scales.

[sharptonn]

I have a few sets of NOS replacement 5/8 Satinedge scales left.
Say DublDuck on one side, Satinedge on the other. Slightly yellowed, I suppose. Some shelf-wear, but I have polished the scratches out of some in the past.

[yondermountain91]

I looked as closely as I could at the pivot area as one side is broken and it doesn't look like the steel is completely gone so I'm going to stay optimistic about the whole thing. I will definitely hone her up before even unpinning it. Thanks guys for responding, not going to lie, really don't like the search feature. It works too good, and I find myself getting lost in the depths of the forum. Spending hours browsing through it, learning everything except what I set out to learn, lol However that's probably just my fault for being so easily distracted.

[Euclid440]

Yes, there are several threads on Ducks, Acetone soak will remove bolsters, be careful they are thin. Clip off just above the bolsters and soak a few minutes, if still stuck on still wait a few more. They will come off easily eventually.

Do not try to pull them off, you will ruin them. Or use a paper cup and let the celluloid completely dissolve, remove the bolsters and toss the goop. I have done both ways.

10pups also did several restores with new scales, a few years back and posted some tutorials.

An advanced search for (Double Ducks, 10pups) will yield several of his duck threads. You might PM him for advice. I have seen his work in person, stunning.

Watch for cell rot on the razor, they are notorious for rot, which is probably why the scales are broken, very brittle.

You should see if you can get a clean bevel and edge on it, before investing a lot of time.