Thread: 7/8 Hollow grinding

Originally Posted by jfk742

I’m in the middle of finishing a bellied full hollow. That damn line was really difficult for me to get straight and even. Are you keeping it or grinding it out after heat treat?

Are you using a jig? I use a homemade version of a knife grinding jig, I make my primary hollow then paint the blade with layout dye. I then scribe a line where the belly should land according to a hollow grind calculator I use online. I use the corner of the wheel and watch as I creep up to the scribe line. When it's pretty much there I then do some passes to smooth everything out to get a nice crisp line. I blend my bellies into the edge grind to get a bit of extra thinness but I think once I get the knack I'll start leaving them in. Looks more impressive to have that nice clean line I think. Might get in the way of sharpening decades down the road if left in however.

There were some old American razors that had the Korn Patent grind which had the belly left distinct. Also the Clauss New Departure razor.