Results 1 to 3 of 3
Like Tree2Likes
  • 2 Post By gssixgun

Thread: Uneven or bent

  1. 07-12-2024, 05:02 PM #1
    Cattleman02
    Cattleman02 is offline
    Senior Member
    Join Date
    Apr 2024
    Location
    La Junta Colorado
    Posts
    170
    Thanked: 2

    Default Uneven or bent

    How do you tell if a blade has uneven hone wear or bent?
    Reply With Quote Reply With Quote
  2. 07-12-2024, 07:03 PM #2
    gssixgun
    gssixgun is offline
    At this point in time... gssixgun's Avatar
    Join Date
    Jun 2007
    Location
    North Idaho Redoubt
    Posts
    27,025
    Thanked: 13245
    Blog Entries
    1

    Default

    Place the tang on a flat surface push down at the pivot hole with your finger
    Note the relation to the surface flip it over and do it on the other side





    Once you do this a few times it gives you perspective to just look at them in the scales
    rolodave and Tathra11 like this.
    "No amount of money spent on a Stone can ever replace the value of the time it takes learning to use it properly"
    Very Respectfully - Glen

    Proprietor - GemStar Custom Razors Honing/Restores/Regrinds Website
    Reply With Quote Reply With Quote

  3. The Following User Says Thank You to gssixgun For This Useful Post:

    Cattleman02 (07-13-2024)
  4. 07-12-2024, 08:11 PM #3
    bouschie
    bouschie is offline
    Senior Member blabbermouth
    Join Date
    Jun 2013
    Location
    Pompano Beach, FL
    Posts
    4,038
    Thanked: 634

    Default

    I place a straight edge along each side of the spine. I fill low spots with electric tape until straight then cover all with one layer of tape.
    Reply With Quote Reply With Quote

  5. The Following User Says Thank You to bouschie For This Useful Post:

    Cattleman02 (07-13-2024)
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules