Thread: As requested... Adjustable Pins!

I've had success filling the hole with epoxy and drilling a 1/16" hole through it.

I know it's an old thread - but I wanted to post an example of filling the pin hole with epoxy to get a tight fit.
This is what I did on my favorite razor - the hole was an oval, so epoxy was the best answer .

Originally Posted by fotoguru

I've had success filling the hole with epoxy and drilling a 1/16" hole through it.

Originally Posted by fotoguru

I know it's an old thread - but I wanted to post an example of filling the pin hole with epoxy to get a tight fit.
This is what I did on my favorite razor - the hold was an oval, so epoxy was the best answer .

Did you just fill it entirely then drill a new hole? How has the epoxy held up with use? Thanks!

Yes - just filled it and drilled a 1/16" hole. It's JB weld which is overkill for this application. High strength/wear resistance aren't really that important here. Pretty much any epoxy will hold up well for this.

Originally Posted by rodd

Did you just fill it entirely then drill a new hole? How has the epoxy held up with use? Thanks!