Results 1 to 10 of 21
Hybrid View
-
08-04-2009, 11:38 PM #1
Ask and you shall receive..
http://straightrazorpalace.com/shavi...hie-razor.html
Its a long thread, enjoy and good luck with the razor
Bob
-
08-05-2009, 10:58 AM #2
- Join Date
- Jan 2009
- Location
- Bangkok, Thailand
- Posts
- 1,659
Thanked: 235Just an update on how it's going. I have just finished chopping off the toe. Now I am going to think about reshaping the end into a barbers notch like it used to have. But that might have to wait until my fingers heal. Its hard work doing this with just a diamond file and no vice.
-
08-05-2009, 12:54 PM #3
You are a patient and persistent man. Nothing like taking a lemon and making lemonade. Nice save.
Be careful how you treat people on your way up, you may meet them again on your way back down.
-
08-05-2009, 03:36 PM #4
- Join Date
- Jan 2009
- Location
- Bangkok, Thailand
- Posts
- 1,659
Thanked: 235Patient, persistent and damded stuborn. Just ask my wife.
-
08-05-2009, 03:45 PM #5
You did that without a vice? Ouch. Blisters, or just very sore?
Nice job on it, I look forward to seeing how it ends up!
-
08-05-2009, 03:58 PM #6
- Join Date
- Jan 2009
- Location
- Bangkok, Thailand
- Posts
- 1,659
Thanked: 235No blisters, just a bit sore. But this did take me about three days to get through. It has made stropping a bit hard though. Now I'm trying to reshape what is now the toe. I have wrapped some material around the blade and clamped it in a D clamp. This gives me something to rest against the edge of my desk. I'll post some pictures tomorrow to show my progress so far.
-
08-06-2009, 11:08 AM #7
- Join Date
- Jan 2009
- Location
- Bangkok, Thailand
- Posts
- 1,659
Thanked: 235Here is an update of where I'm up to. I have just finished redoing the barbers notch. Because I don't have a vice I wrapped the blade in a rag and then clamped it in a D clamp. This gave me something to rest against the edge of my desk. It didn't take any where near as long as I thought it would. Now I have to polish it up and I'm planning on cutting down the original scales to fit. Once its all polished up and put together it should look good.