held together with Superglue.

[aaron1234]

So I got this razor and I wanted to keep the scales original but the holes were too big. So to correct that I drilled them out a little bigger and super glued some 3/32 brass tubing in them. Sadly though it didn't work as well in practice as it did theory. When I tried to pin it especially at the wedge I couldn't tighten it properly on the wedge. Something easy to fix but kind of annoying. It also came out completely invisible.

Sent from my SAMSUNG-SM-G935A using Tapatalk

[aaron1234]

Sent from my SAMSUNG-SM-G935A using Tapatalk

[aaron1234]

Sent from my SAMSUNG-SM-G935A using Tapatalk

[dinnermint]

Lookin good. I do believe sharptonn did a tutorial of a similat situation.

[32t]

Were they thicker than the scales? Did the glue come loose so the scales widened out and didn't hold tight to the wedge? A washer under the rivet should hold the scales tight. Is what looks like a washer actually the tubing? If so could you then peen the tubing?

;Just my random thoughts looking at the pics...

[aaron1234]

Were they thicker than the scales? Did the glue come loose so the scales widened out and didn't hold tight to the wedge? A washer under the rivet should hold the scales tight. Is what looks like a washer actually the tubing? If so could you then peen the tubing?

;Just my random thoughts looking at the pics...

Your pretty much right on everything. I had to hand sand to prevent the tubing from heating up and ruining the glue. And because the brass was harder than the horn the tubing kept trying to stick out from the horn which is not a problem on the outside but on the inside it causes issues. I had to sand it in a funny matter to keep that from happening. I probably should havebevelled out the inside of the tubing with a drill bit for the wedge. I did eventually get it to hold tight to the wage but It didn't want to do that at first. As for the washer under the river my problem was that the scales kept trying to move underneath the pin and it kept wanting to change its Centering. And you can't see the tubing once it has been penned the washers cover them up completely. If you didn't apply a washer then you could probably peen directly to the tubing and get a really neat effect. To me this would be a really good idea for wood scales If you want to try to peen a little tighter than you would with just a super glue reinforcement.

Sent from my SAMSUNG-SM-G935A using Tapatalk

[xiaotuzi]

That looks great! Nice blade, like that thumb notch

[aaron1234]

just remembered that I should have posted a picture of the other side as well.

Sent from my SAMSUNG-SM-G935A using Tapatalk