Thread: Using metal polisher on straights

Hi,
Is it a good idea to use metal polisher on straight razors? Thanks.

You can use Maas(metal polisher)it is highly recommended,in fact i use it often myself to clean off water spots,oxidation and minor scratches. This stuff is great. And a lot of the members on this forum use it as well.

If you go to the workshop forum where you posted this question there is a 'sticky' thread on everything you always wanted to know but were afraid to ask. Here it is here. I'm assuming by metal polisher you mean a buffer ? If it is just metal polish on a paper towel you're talking about that is fine if there is no gold wash. It will take that right off.

I was already considering buying maas polisher

Would this one be good enough for straight restoration or should I get the one in tube:

Its all the same stuff, just different size containers. So it just depends on how much you need..!

A little Maas or any other metal polish goes a long way, but it has uses on many other things as well. I wouldn't recommend a large tub. Be careful when working on a blade (noticed your post count and don't know your experience) as that edge will "bite" you if you aren't careful. I've cut myself on quite a few "dull" razors, but only nicked myself on sharp ones...go figure.

I bought a can of Semichrome (similar stuff) like that and wish I would have stuck with the tube. Unless you use it a heck of a lot the tubed variety stays moist while the stuff in the can will tend to dry out on you.

Originally Posted by ferroburak

Hi,
Is it a good idea to use metal polisher on straight razors? Thanks.

Power tools? no!

Light polish like "MAAS", "Flitz" or "Happich Simulchrome"
applied with a "Qtip" or with a pinch of tissue paper is commonly
done. Caution: gold wash will be rubbed away by polishes.

Do occasionally apply a light protective coat of something like mineral oil
or Pure Camellia Oil including the pivot and tail to prevent rust.