Results 1 to 10 of 48
Thread: 2 bladed razor
Hybrid View
-
02-01-2011, 07:56 PM #1
Thank you sir. This is very informative. It would seem grinding down the tangs to make the blades center as best possible will be the biggest challenge! The measurements and photos will be of great help! Thanks again, Tom
-
11-13-2011, 02:15 PM #2
sharptonn how are you doing in manufacturing of the double razor? At what stage you have stopped. I ask not with idle curiosity. The matter is that I want to make such razor.
-
11-13-2011, 03:34 PM #3
lezcha, I suppose I have not had time to work with it lately. I have saved these photos from Ignatz which will prove to be quite valuable as I proceed. I will PM you when I take it up. I felt that much grinding and fitting will be required to do a proper job. Also the measurements which Ignatz has so graciously provided will be the key to success. If you go ahead before I do, Please post here! Regards, Tom
"Don't be stubborn. You are missing out."
I rest my case.
-
11-14-2011, 07:39 PM #4
sharptonn , Greetings! Today has begun work. Here two preparations, has made хонинг. I think to make as at the normal razor, with tails. I apologize for quality of a photo, removed on work as phone. Carbonaceous steel У7 width of a butt 4,5мм is dense width 20мм. Tomorrow if there will be time will continue.
-
11-14-2011, 07:43 PM #5
I need to subscribe and see how this turns out.
-
11-14-2011, 07:46 PM #6
-
11-14-2011, 07:51 PM #7
I wouldn't like to risk and spoil pair still good razors. If that that also doesn't turn out, will throw out it is not a pity
-
04-04-2012, 04:10 PM #8
Tom you are like the straight razor Dr. Frankenstein with all these experiments and your "razor chimes" lol