Results 1 to 3 of 3

Thread: Bug Bites

  1. 04-12-2011, 07:08 PM #1
    pmc
    pmc is offline
    Junior Member
    Join Date
    Nov 2010
    Location
    San Diego
    Posts
    7
    Thanked: 0

    Default Bug Bites

    Gentlemen,
    I have a couple razors with varying degrees of bug bites in the horn scales that I want to plug. I'm thinking of using JB weld or PC10 since their grey color should blend with the horn color. Are there other materials I should consider?

    PMC
    Reply With Quote Reply With Quote
  2. 04-12-2011, 07:45 PM #2
    gssixgun
    gssixgun is offline
    At this point in time... gssixgun's Avatar
    Join Date
    Jun 2007
    Location
    North Idaho Redoubt
    Posts
    27,052
    Thanked: 13249
    Blog Entries
    1

    Default

    I think when you start sanding you will find that the horn is either Black or very very Dark Brown... There might have been some Grey out there but I haven't found any "Yet"
    I use Brownell's Acra-bed which comes in Black or Brown... but any colored epoxy should do fine... I am of course assuming you are going to sand these down smooth...
    Also Neat's Foot oil works wonders on them but only use it after you have done the repairs...
    Last edited by gssixgun; 04-12-2011 at 07:53 PM.
    Reply With Quote Reply With Quote
  3. 04-13-2011, 02:24 AM #3
    pmc
    pmc is offline
    Junior Member
    Join Date
    Nov 2010
    Location
    San Diego
    Posts
    7
    Thanked: 0

    Default

    Thanks gssixgun.
    I have some acra-bed in the garage, I'll give it a try.

    PMC
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules