Results 1 to 10 of 13
Thread: What material are these scales?
Hybrid View
-
06-10-2011, 09:07 PM #1
-
06-10-2011, 09:13 PM #2
- Join Date
- Jun 2007
- Location
- North Idaho Redoubt
- Posts
- 26,986
- Blog Entries
- 1
Thanked: 13234Leather is not "Common" but I do have 3-4 sets in my Bench Box that I have taken off for restores,,, I also have seen Pressed Paper -BUT- they were on a "Sales/Advertising" razor basically a Straight Razor Disposable
-
06-10-2011, 09:28 PM #3
Thanks for the info Glen, appreciated
It's just for my interest really, as I don't really like the way they look and will probably attempt to make some from wood myself
-
06-11-2011, 04:40 AM #4
Never heard of leather scales, but it sure looks like leather. Micarta should finish up better than that. The only rough finishing micartas are coarse fabrics like burlap or canvas. Those look obvious.
Phillip
-
06-11-2011, 05:20 AM #5
Most assuredly leather. I hate those things, they leave little bits of leather between my fingers. Drives me nuts. Believe it or not if I see them in an antique store I will not touch the scales, I usually use plastic grocery bags as a barrier.
I have seen one leather scale restore that I liked, but for the life of me I cannot seem to find it in my bookmarks.
-
06-11-2011, 06:28 AM #6
I agree, it might look quite good when new and polished, but is unloveable in its old age. Comes to all of us, I suppose. I don't know what extremely old whalebone looks like, but probably not like that. Hard vulcanised rubber is another possibility, but I'm nearly sure these scales are leather.
It would have been compressed, and when people tool designs into leather, they moisten it first with hot water - not soak it, and not boiling. Boiled leather is another possibility, since it was used for making armour, and "cuirass" derives from the word for leather. But that hardens and shrinks the leather, and would have to be done with sheet leather flattened on a board, from which the scales would be cut afterwards.
Modern technology offers the possibility of impregnating it with something better than could have been used in the past - cyanoacrylate or cellulose sealer, say, with the surplus squeezed out between sheets of non-adhering plastic.
-
06-11-2011, 07:20 AM #7
So... I have to ask...
How 'bout a month long soak in Neets?
... and even after that how in the world would you ever pin 'em tight enough to hold the blade up for a picture?
Seems like a rescale is the only obvious choice - unless nostagia is the goal.