Results 1 to 4 of 4
Thread: advice
Threaded View
-
08-19-2006, 03:34 AM #1
advice
So this is part two of my post in the general forum. So I have this gorgous mint Boker King Cutter except for the fact that the very edge of the blade at the toe end and I mean end has about a 32nd of an inch chip in the edge. The chip is actually about 3/32nd of an inch from the toe end of the blade.
So am I better off grinding down just the toe end where the chip is and throwing off the geometry of the blade or am I better off grinding down the entire blade and basically starting over. Its a 6/8s.No matter how many men you kill you can't kill your successor-Emperor Nero