Thread: advice

So this is part two of my post in the general forum. So I have this gorgous mint Boker King Cutter except for the fact that the very edge of the blade at the toe end and I mean end has about a 32nd of an inch chip in the edge. The chip is actually about 3/32nd of an inch from the toe end of the blade.

So am I better off grinding down just the toe end where the chip is and throwing off the geometry of the blade or am I better off grinding down the entire blade and basically starting over. Its a 6/8s.

How big is the chip? Pictures?

Maybe just round it off a bit.

X

Originally Posted by xman

Maybe just round it off a bit.

X

Yea thats the way I was heading. Since its at the very tip of the blade almost, it should shave fine. I think a 32nd of an inch chip can propably be smoothed out with the 4K in short order. Thanks for the advice..