Results 1 to 3 of 3

Thread: Epoxy finish

  1. 10-07-2006, 07:52 AM #1
    ToxIk
    ToxIk is offline
    Senior Member ToxIk's Avatar
    Join Date
    Apr 2006
    Location
    Toronto, Canada
    Posts
    667
    Thanked: 73

    Default Epoxy finish

    Just wondering if anyone's tried using an epoxy finish (as opposed to say CA). There are epoxies out there that cure to very nearly transparent, and polymerize to a hardness comparable to CA.

    I did a little experiment using a little $2 tube of lepage epoxy. Mixed it and spread it out over my test surface. It cured to a nice hard clear polymer, the only difficulty I had was eliminating airbubbles.
    Reply With Quote Reply With Quote
  2. 10-07-2006, 09:32 AM #2
    randydance062449
    randydance062449 is offline
    Hones & Honing randydance062449's Avatar
    Join Date
    May 2005
    Location
    Saint Paul, Minnesota, United States
    Posts
    8,023
    Thanked: 2209
    Blog Entries
    1

    Default

    Air bubbles are the problem with epoxy and can be minimised by keeping the temp up before mixing. Getting an epoxy that dries hard can be a trick but they still all feel like plastic when done.

    Just my two cents,
    Randolph Tuttle, a SRP Mentor for residents of Minnesota & western Wisconsin
    Reply With Quote Reply With Quote
  3. 10-07-2006, 11:56 PM #3
    Traveller
    Traveller is offline
    Senior Member Traveller's Avatar
    Join Date
    Oct 2005
    Location
    Port Isabel Texas
    Posts
    804
    Thanked: 57

    Default

    System 3 Laminating Resin 2 part epoxy
    System 3 Clear Coat 2 part epoxy

    If you send me an e mail in about a month when I get home Ill send you a sample of each Best Regards Gary [email protected]
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules