Thread: My pins do not meet my approval

Agreed to many light taps. Don't really think can strike too light. Always moving and rotating razor so non striking side doesn't flatten out.

After pinned, I sand wedge side, making sure it is a completely smooth union. Due to this, I also end up doing a final pass over much of the razor once again with MicroMesh.

Once at around 2400, I'll swipe the pins a few strokes up to the 12000. Leaves pinned heads with a tight look. I like that better than power polish. Using something like a dremmel tends to oval the heads, and removes sharp edges of pin and washers. For me, I don't like that detail being removed.