Thread: Tips for finishing scales in sliky smooth, high gloss surface? Okay to polish shank?

I think thin superglue (CA) yields some pretty high gloss results if you put enough coats on.

I did a bit of reading on Madrone wood as I had never worked it before, what most people where saying is it is similar to Walnut.. To me that means you can go just about any direction you want when it comes to finishing...
Ease of use - Wipe on Poly, Teak Oil, Danish Oil
Middle ground - Tung Oil, Polyurethane, Gunstock finishes
More of a Challenge - CA, Epoxies, these are really easy once you have everything set up, but tuff the first time through

For beauty it is hard to beat a well done Tung Oil finish or a CA finish

Glen beat me to the CA recommendation, but in the process, also gave you the full context of the different approaches and the degree of difficulty. There's a reason we like him so much.

I thought I saved the thread about his tips for CA finish, which I used for my first few scale projects, but naturally its nowhere to be found right now. Its worth searching for. 'Something like 'tips for using a CA finish'.

The last one came out like this:


Have fun doing it. Each one you do will get better.

That was a good thread, after tons of people added to it,, Good thought Rob

It also gives an idea of all the steps involved with them

http://straightrazorpalace.com/works...ints-tips.html

Looks beautiful. Going to do my first real rescale very soon. Just reading up on it now.

Just my 2 cents. When I do pens, I take it down to 600 grit then apply a product called EEE-Ultrashine which you should be able to get at any good woodworking supply house. After that, I go to the final finish whatever that may be.
The EEE is made for using on a lathe, but you should be able to use it on a felt wheel YMMV. I'd try it on a scrap piece first. The other thing you might try is what I use on pipes: jewelers rouge followed by white diamond polishing compound. Again, YMMV so experiment first.

Thanks gssixgun for the CA suggestion. I found the thread in the sticky. Very detailed instructions. I'm looking forward to trying it out on some test pieces later.

So there shouldn't be any problems with polishing the shank to a mirror finish?

I'll post pics of my "upgraded" razor when I'm done with the new scales and polish. Might be a few weeks though.

Thanks again to all!

I always polish out the "shank" if the razor is out of the scales no sense in putting it back in with anything but clean bright steel...

Just to clarify you are talking just polishing, no grinding on it right ???

Originally Posted by Flatland2D

Thanks gssixgun for the CA suggestion.

you're welcome.