So far in, whenever I go for a CA finish, quite often I seem to run into one particular problem. Whenever I finsh with CA, the finish is always thinner around the edges. Then when I go to sand everything down, I endup sanding through the CA and have to re-apply around those areas.

I figure this is a normal problem, seeing as it's always hard to properly seal sharp edges and corners. I'm just wondering if other people seem to have the same problem, and what may be done to mitigate it?

As an idea, I figure next time, I'll try resting the scales in positions such that, when drying, gravity draws the excess to the edges so that more cures at such areas.