Yea that was kind of the idea. Didn't want to make it too modern...
Printable View
Cudarunner - Check out the side by side - I thought you would enjoy
Attachment 234541
Attachment 234556
The pencil on the left is straight out of the Mono 100 box.
The pencil on the right has been machined using the two stage manual twistulator which you can see in the pic.
;)
WW243 i must say that is a fine job. perfectly uniform with a nice smooth finish. looks very sharp too. i bet it writes like a dream. do you do custom work?
,,,,,,,,,,,,,,Attachment 234592
Bill , very precise and engineered angles with very little wind drag and ergonomically crafted, should be able to write 400 words per minute or able to stab someone in the eye at Mach speed
O.K.,, its not a Swaty, It's actually made by the American Hone Company of Olean, New York; but I call it my Beat Up Swaty.
I have Swaty hones but they are just display. This barber hone has never seen a razor, but is used as much as any other hone in the Sharpening Den(cramped kitchen). I use it to smooth out the edge on my EDC knife & other edged tools. It does a great job!
Some scrap leather & a piece of MoleSkin on the inside to keep the snap off the stone.
It has always just sat in the drying rack until the next use, so I gave it a home of its own out of respect for the fine service it gives me.
Thanks for looking,,,,:)
Attachment 234646
Attachment 234647
Attachment 234648
Attachment 234649
Attachment 234650