Results 1 to 10 of 48
Thread: IXL Washington Works
Threaded View
-
04-19-2014, 01:13 AM #6
Thanks! Coming from a craftsman like yourself, means a lot!
Thanks! I would say you have NOO idea, but I know you DO! Anal sizing, precise pin hole drilling, afraid of when the bit breaks thru...trimming the front of the wedge till 'ain't no more', aluminum pop-rivet pivot bushing (don't tell Pixel!) Oversizing the holes and sizing the collars so the 2 on the wedge end meet with some crush room, same on top. Hammer was not tapping, just ticking! About 5 or 6 mockups, CAing the wedge to the cracked scale, Razor silliness. I just cannot believe it closes center. Pure luck!
Thanks, Matt! I appreciate that!Last edited by sharptonn; 04-19-2014 at 01:23 AM.
"Don't be stubborn. You are missing out."
I rest my case.