Thread: W&B 6/8" Wedge - Vintage rebuild to original specs

Originally Posted by TwistedOak

Searched "sleeving pivot" in the box at the top of the page and came up with these...

1
2
3
4

Literally the first four hits.

Excuse my ignorance.

Originally Posted by BoozeDaily

Excuse my ignorance.

no worries, folks just forget to search the wealth of information already covered on this site. At least you didn't make a new thread for it.

Originally Posted by BoozeDaily

I have a very similar W&B but I'm hesitant to get started on it since there is a lot of pitting near the edge.

Booze I see you have some other responses for the pivot hole, so you see there are many ways to skin that cat,
as for starting your resto with a heavily pitted blade, it is highly recommended by many to set a bevel & confirm the edge is complete and free from pitting near the edge before you start, then confirm your path foward from there, if you want to shave with it or just display as to how much effort gets put into it rather than find out later it is not a shaver after many hours of sanding.