Results 1 to 10 of 11
Thread: ERN 1166 in Stained Oak Scales
Hybrid View
-
01-27-2009, 12:32 PM #1
The centering part took a couple tricks. They first was to sand the inside pieces flat and then the second was to not install the internal (thrust?) washers. For some reason (maybe added play or wiggle room) they would cause the blade to be off center. Shimming the blade to either side with an extra one didn't seem to work either, but for some reason, no washers worked out.
Thanks for the positive feed back. More to come eventually.
Mark
-
01-28-2009, 12:15 AM #2
May I add to the chorus of approval, that is a terrific job, Very well done.