Results 1 to 10 of 25
Hybrid View
-
07-02-2013, 06:39 PM #1
- Join Date
- Jun 2013
- Posts
- 120
Thanked: 268Thank you Bob.
It is no secret at all. I used silver solder paste (meltingpoint 650°C). The difficulty was not to harm the hardness of the blade. Therefore i covered it with wet tissues and added new water while the hole soldering process. To get enough heat i used a propan/oxygen burner with a very fin but hot flame. It was a hard task but it worked. Only the tang is soft, the blade itself did not loose any hardness.
cheers,
Ulrik
-
-
07-02-2013, 08:30 PM #2
-
07-02-2013, 11:26 PM #3
- Join Date
- Aug 2011
- Location
- Upstate New York
- Posts
- 5,780
- Blog Entries
- 1
Thanked: 4249