Thread: Gas forge for heat treating?

For a burner lookup ron reil and read his info.
The basics are a pipe with and end cap.
Drill a wire gauge 60 hole into the end cap. 3/4" pipe will be fine. This will be your burner.
You will take another piece of pipe large enough to slide over the 3/4" burner. In one end you will drill out numerous holes about 3/8" diameter. These will be your venturi where the air will be sucked in and mixed with the gas.
You will also need a short piece of pipe to fit over the venturi pipe. This will function as a "choke" to control the amount of air being mixed with the propane. It will help in setting a neutral
flame.
This just a rough outline.