Results 1 to 10 of 77
Thread: 1st attempt making a razor
Threaded View
-
02-28-2010, 08:00 AM #12
For jimps, I started them off with junior hacksaw then used a small v section modelers file. When wide enough I chages to flat file to create the rectangular section. Putting them in individually I found a bit tricky getting spacing even but I wanted them quite chunky for this razor, they're not perfect. Will invest in checkering file for my next razor and go for finer jimps.
-
The Following User Says Thank You to Deckard For This Useful Post:
ScottGoodman (02-28-2010)