Results 1 to 10 of 44
Thread: Straight razor - starter project
Hybrid View
-
09-01-2011, 11:10 PM #1
There you go then. I guess the only real way is to just start trying and see what comes out. Still have to figure out how to hollow by hand though....
-
09-02-2011, 05:12 AM #2
-
09-02-2011, 05:34 AM #3
Sen Zen was the name of that post. Interesting idea. I have an old file that is pretty much junk. Think I could use the grinder wheel on a dremel or the sanding drum on my drill press to grind the file down? Worth a shot I guess. I'm not wanting to make a full hollow razor, just something a little bit less than a full wedge.
-
09-02-2011, 10:50 AM #4
- Join Date
- Sep 2009
- Location
- SE Oklahoma/NE Texas
- Posts
- 7,285
- Blog Entries
- 4
Thanked: 1936Here's what I used, it's a wet grinder, so you can finish the hollow once the heat treat is done. Runs about $50 @ Sears. May be slow, but it works...I did my first 4-5 razors with this one:
Southeastern Oklahoma/Northeastern Texas helper. Please don't hesitate to contact me.
Thank you and God Bless, Scott
-
The Following User Says Thank You to ScottGoodman For This Useful Post:
spazola (09-02-2011)