Originally Posted by
Vasilis
The reason we lap the stones is to keep them flat, not de-glaze them. And the use of slurry is an 100% legitimate method on honing, on the stones that can create slurry. Slurry from an Arkansas stone should be very fast, only, the stone wasn't meant or "made" to be used this way. Arkansas stones are getting glazed by their nature, because of their hardness and since you dislike that feature, you can try a softer stone that does not get glazed. When I'm thinking about Arkansas stones, some types of man made, coarse and hard stones that initially are super fast until they lose their speed come to mind. I agree that there is no "right" or "proper" way to use this or any stone. Place the blade on it, water or oil depending on the type of stone and hone until the edge has the finish of that stone, if it gets hollowed lap it, and clean it after use, like all stones. Their performance changes depending on pressure as you said, but the effect is far more noticeable the softer the metal it is. If I were to use the stone on bronze, copper or gold, I would be delighted by its speed and wouldn't care about the glazing effect it has, but on hard steel, it's a slow stone, and on any other natural stone of similar grit, if you give it a coarse surface, I don't think Arkansas would be faster than that stone as long as it's a good natural stone. Apples to oranges, you can't say a polished surface of a Dalmore yellow or Wastilla is slower than an Arkansas stone with a coarsely lapped surface, these too have this characteristic. Every stone has its tricks including the Arkansas stones, but I'm starting to wonder if your opinion is a bit biased about Arkansas stones, since you've been using them more than other naturals of similar grit.