Quote Originally Posted by Utopian View Post
I had the Chosera 600 and 800 for at least three years before I finally broke down and got the 1k. I got them at the time when the mantra was that you could not go below a 1k hone without causing more damage than was worthwhile considering the cutting capacity. I found that this was not the case for these particular hones, as well as the Chosera 400. Each of them is very helpful for aggressive restoration work on the edge. Each of them easily can be followed by the 1k.
Which would you recommend for chips and quick bevel setting? The 400 seems too low and the 800 seems too close to the 1k, I figured the 600 would be perfect.

If you don't mind, what to your recollection were the differences between the 600 and the 800?