hone support

[Oustoura]

hi

i really need a advice to choice a hone support while i give them a 'younger edge'. i use also hone but thin DMT so i looke for a support which will not be glissed on them table and will fit the hones i have and also with the DMT's.
PS: if they existe on aliexpress etc. i would like to know because they are really not too expensives
thanks.

[Gasman]

Universal stone holder? Is this what you are looking for


I did not see one on aliexpress but i don't shop there so i might have missed it.

[Oustoura]

Universal stone holder? Is this what you are looking for


I did not see one on aliexpress but i don't shop there so i might have missed it.

yes i look for this kind of stuff. it does slide ont the table while honing?

[BobH]

You could use some non slip netting on the table to place the hone on. If you need to raise the hone use a black of wood cut to fit the size of the hone and put non slip netting on both sides of the wood block. Not as posh as a universal stone holder but it will do the job.

The link is for example only https://dycem-ns.com/non-slip-netting . I am sure you can easily find this stuff.

Bob

[Gasman]

I use the holders and the netting Bob showed. The holder is really not needed if you go with a block of wood or rubber and the netting.

[tintin]

I've set my Naniwa (the ones without the built in stand) on my DMT and it seems to hold them pretty well without sliding.