Results 1 to 10 of 22
Thread: Norton not Cutting
Hybrid View
-
01-13-2013, 03:06 AM #1
David, If you haven't been taping the spine, and as you said, doing hundreds of strokes you can put a lot of wear on the spine, especially if your using pressure. If you get uneven wear on the spine it can be a real headache to fix. I recommend you use tape on the spine while learning to prevent the wear. After you've honed for awhile and become fairly proficient, then decide if you want to continue taping or not.
For right now it might be a good idea to send it out to be professionally honed again. You can find those services listed in the classifieds and vendors section, both linked below.
If you decide to continue, the others have given some good advice.
Vintage Blades LLC has Lynn do their honing, so tape wasn't used and I'm sure it was shave ready and correct to start.
Best Regards,
Howard
Edit: Here's a link to gssixgun honing videos. You'll find videos on most all the different hones, including the Nortons. Hope it helps.Last edited by SirStropalot; 01-13-2013 at 03:35 AM.