Thread: King hone

www.axminster.co.uk you will need to check whether it is a g-1 or a different 8000 grit stone, because king make a variety of stones, but from the photo's i can tell it is one of their higher end ones because they sell them with a nice plastic base.

I would be tempted to go for the 10000 grit stone axminster sell, which is a Kitayama (Norht Mountain) stone. When i have some cash i think i will buy one of them.

Thanks for the link! I think their combination stone is a lower end one: http://www.axminster.co.uk/recno/4/p...ones-22468.htm. It is described as a beginners' stone.

The one I am looking for is a King Deluxe stone.

The one on the left on this pic may be a Deluxe hone: the word "KING" in a circle.: http://www.axminster.co.uk/showimage...title=Japanese Fine & Polishing Waterstones

I am not sure that one has many advantages above a coticule or Thuringer followed by stropping.

Originally Posted by ernestrome

www.axminster.co.uk you will need to check whether it is a g-1 or a different 8000 grit stone, because king make a variety of stones, but from the photo's i can tell it is one of their higher end ones because they sell them with a nice plastic base.

I would be tempted to go for the 10000 grit stone axminster sell, which is a Kitayama (Norht Mountain) stone. When i have some cash i think i will buy one of them.

I'm in the UK also, so took a look at the Axminster site. I'm just starting out with straights and am trying to get a basic set of tools together.

I've just bought a vintage (read: blunt) razor from an antiques shop and need to get it sharp. I've also ordered a Norton 4000/8000 stone. Would the 10,000G stone sold be Axminster be something I could use after coming off the Norton, before going to a hanging strop? Or might I be better off with a pasted paddle?

It would be something you could use, alternatives would be yellow coticules, thuringens etc. I am aving up for the 10K, so if you ddn't like it, i'm sure we could sort something out!

I've had a 1000/6000 King for years due to my collection of Japanese knives, primarily sushi knives. I've used the 1000 side instead of sandpaper to grind out an edge on my eBay razors. As far as I can tell, it works well for that. These Japanese stones need to be immersed in water for about 10 minutes or until the bubbling stops prior to use. I just sold a rather expensive sushi knife to a friend who is a half Japanese sushi chef and he said that he was going to buy a Belgian blue for the knife, the 4X10 Belgian blue that Howard sells. The one issue that makes Japanese stones difficult to use is that they must be flattened after each use or they develop a noticeable concave sway. Of course this is when used with sushi knives where a lot of steel is being ground away. But they do wear away quickly and so need constant attention. My experience with razors is very limited and recent but I just feel that the Japanese whetstones are better for the steel than sandpaper. I have to believe that the cut that the stone makes on the steel is not as deep and is smoother when compared with sandpaper.