Thread: Getting a harsh edge from Suehiro 20k

Hint;

Stop thinking and speculating and go try it

1 Layer of Electrical tape at the 1k level to set the hard bevel then dropping the tape at the 3-4-5 k level takes mere seconds to even out the bevels less then 20 laps
It eliminates the deeper 1k scratches that you would leave on the spine..


I have a Vid of exactly how little one layer of tape changes, things but honestly just go try it yourself the AHT and dulling the edge is a good way of testing it...
Set the bevel at 1k with 1 layer of tape so that it passes your AHT, then lightly kill the edge so that it doesn't pass, then remove tape and re-set the bevel using your 3-4-5 k hone and see just how little it takes...

(Does not apply to using multiple layers for geometry issues and Torque while honing plays a large effect on spine wear in general)