Results 1 to 10 of 30
Hybrid View
-
11-14-2010, 03:46 PM #1
I agree Jimmy. From what I saw of the edges from CrOx (after JNat), I would rather shave after JNat directly. I never shave after CrOx anyway (rarely use it)...The exercise for the stone to stone progression was to observe the patterns each stone leaves behind on the edge, not to make this a typical honing regimen. My typical honing regimen would be exactly as you describe...Coti OR JNat and test.
PS: I never take it to the diamond...what I use is to raise slurry on JNat with DMT325 and use dilution to finish the edge.
As for the test shaves, that is absolutely dead on...The shave today was absolutely fabulous...smooth as butter. That was with the edge after JNat (w/ diamond slurry and then water) + stropping. At some point, I will repeat these tests with each stone/abrasive and test shave to correlate the "edge look" with the shave result (if any). I would like to eliminate my bias from this...so maybe after doing this, I will have someone around me shave test and tell me what they think .
-
11-14-2010, 03:52 PM #2
Shave test Results
I really enjoyed the shave today. The edge was with Asagi (with diamond slurry with dilution and finally with water) + stropping on premium IV leather.
Smooth as butter . In the next few weeks, I will finish the edge of this blade using each of the stones alone and shave testing.
-
11-14-2010, 05:00 PM #3
-
The Following User Says Thank You to richmondesi For This Useful Post:
BladeRunner001 (11-14-2010)
-
11-16-2010, 02:11 PM #4
- Join Date
- May 2010
- Posts
- 85
Thanked: 72this is very interesting, thanks for posting
-
The Following User Says Thank You to jasp For This Useful Post:
BladeRunner001 (11-20-2010)
-
11-17-2010, 03:02 PM #5
another thanks
I also would like to say thanks for the images. I use a loop and it has helped alot, but nothing like those images.
Now if I have the selection of hones that were used here, If I did have those I would likely be single and living on someone elses couch!Last edited by scrapcan; 11-18-2010 at 02:35 PM.
-
The Following User Says Thank You to scrapcan For This Useful Post:
BladeRunner001 (11-20-2010)
-
11-17-2010, 04:46 PM #6
-
11-17-2010, 05:01 PM #7